240v

  1. D

    Electric heated tower rad, fused spur outside zone 2 etc

    Bathroom being replaced/rearranged. Washing machine going in bathroom corner via new spur in hall, with upward sloping hole up to new spur backbox. Is it ok to Wago a junction in a 16mm blanked off galvanised backbox, to run a switched fused suppy for the towel rad off to the left (1000 height...
  2. K

    running 240v power tools off inverter attached to car battery

    Need to do a job where there is no mains power. Anyone any experience with this sort of thing for prolonged use with car engine switched on...
  3. eveares

    That's a 120V appliance!

    Oh Dear! :eek: Regards: Elliott.
  4. D

    New 240v dbl sockets from existing existing socket supply.

    I have an existing dbl socket in a 1st floor room that's been extended. The supply comes down the wall from the loft. Is it feasable and safe for a sparx to use that supply for an additional 3 dbl sockets in that room? It would a real pain to take the supply from below the floor in the room...
  5. N

    Nest 3rd Generation Installation 240v

    Hi All, I have recently purchased the 3rd Generation Nest Thermostat. I managed to wire the heatlink up replacing the old controller next to the boiler. The thermostat connects perfectly and this now runs smoothly and I can trigger the heating on and off wirelessly. My next task was to...
  6. eveares

    If the UK leaves the EU, will the nominal voltage be changed back to 240v?

    The other day I was listing to a chat radio station and they were debating about whether we should or should not leave the EU. If we do end up leaving the EU, do you think the official nominal voltage in the UK will ever be re-increased from 230v to 240v along with everything else Europe has...
Back
Top