9651

Hi, due to a knackered keypad, I’ve tried to transfer an old 9800 system over to a newer 9651 system, for my parents. I’ve taken a global tamper approach and things are going OKish. I’ve powered up the system (linking the kick start pins etc) and I’ve assigned names to the 7 Zones (I’ve linked...

Hi all, Newbie here - I've moved into a house with a Scantronic 9651 alarm (and 9940 LCD Remote Keypad). The alarm has been set with the front door to the house as the entry and exit point. All sensors are downstairs. That works fine for when we leave the house, but if I set it a night when...

Just moved into new apartment and noticed the alarm is switched off at the mains and when I switch it on starts to bip. previous owner didn't left any access codes so I have no idea what to do with it to get it up and running?

Hi, looking for some expert advice please as tearing my hair out... My Scantronic 9651 alarm will not arm because of an error on one of my PIR zones (the alarm went off last week). The panel shows the yellow triangle light. When I enter the user code and try to arm, I get the red spanner as...

I've recently taken the challenge of setting up the alarm properly and came across a few issues. Firstly the kitchen PIR (Zone 04) is apparently always open, everything works normally as in it flashes when you walk in front of it but I can't set the alarm unless I omit the zone. I changed the...