alarm fault

Hi I just moved into a new place with an existing Pyronix Enforcer with a deltabell sounder from 2013. It hadn't been used for a while so I changed the batteries in the sounder and all the door sensors and PIRs but I am still getting a low battery error on the control panel which lists all the...

I am about to lose my mind with this IntelliSense alarm system. I moved into my new flat about a month ago, and the first couple of nights in at 11:30pm the alarm started blaring (both at the alarm panel and another box outside in the landing). I had no idea how to turn it off, tried flipping...

I have installed a Texecom Elite 24 alarm wired system and a walk test shows everything is working, A system check also verifies that there are no problems. However, when I enter a user code the system asks do I want to set the alarm and I say Yes by pressing the yes button there are no exit...

Hi all. I’ve used this site a few times but only just now signed up to post something of my own! I had a smart meter fitted recently and during the installation, the power had to be disconnected. When this happened, the alarm sounded for 15 minutes (presumably because the battery is old/dead)...

Alarm working fine until evening set time. Error showing app detected there is something that would normally prevent it from arming. all sensors are showing green on the app if that means anything and the lights are on in every room. What else can I try?

hello I have a honeywell galaxy 2-12 I got from ebay I managed to load defaults and restore the system to when it came from the factory. When I try to full set the system there is no countdown and the bar never goes down. Could any expert tell me whats wrong? Meny thanks!

Hi all, I'm hoping someone can help me. I've recently installed a Honeywell G2-12 into my home. I've installed all the sensors and everything was working fine. Lastly I needed to wire the internal sounder (i've decided I don't require ta bell box at the moment). Whilst installing the internal...

Hi there, I have an Accenta G3 alarm that makes all the right noises to set but then does not activate when I try and set it off. There are no errors showing on the keypad. There are 3 PIR sensors connected and i have completed the walkthrough in Engineer Program Mode and they all work...

Hi I tampered with my alarm keypad whilst decorating. I cleared the tamper with my code but now it states Service due !! I can't clear this anyone give me an idea please

Hi, I have an Veritas 8 alarm system that is less than a year old, when trying to set the alarm this will not set as the panel shows PIR 4 (living room) lit up. On checking it it seems that this PIR is frozen, the red led is constantly on I have made sure that there is nothing in the path that...

Hi I have a powermax express alarm system with a mcs-740 siren. I self installed 10 months ago. Recently (last week)had 2/3 alarms going off all between 3-6 am and on separate days. There was no indication of tamper or break in. Alarm was in armed mode each event. The system flagged a S01...