channel drain

I’m really struggling to understand our home’s gutters. We are end-of-terrace, with one downspout in the front. It’s the single pipe that goes into the grey bricks in front of the fence. I pulled it out yesterday and discovered that it just goes about 12 inches into sandy soil under the brick...

Hi Everyone, I'm going to be installing an Aco channel drain (Raindrain) soon. I will need 3 and a bit sections for the job so I will have to make a cut in one. My question is can I make a cut anywhere along the section then fit an end cap to it? I'm hoping so but It wasn't clear from the docs...

.

I have a bifold door with a DV14 threshold. I am planning to run a channel drain, but do I butt it up next to the threshold, or place it underneath. I plan to run somedecking to to the doors, but would this then butt up to the drain or go over the top? I have created a sketchup to try to...

I am in process of installing Hex Drain (Channel Drain) on the brick patio. I have got the underground drain available nearby where I can discharge the water. (In the picture). As you can see there is a rodding point attached. I am planning install T junction (like this...

Hi everyone the driveway of the house I recently brought needs a new channel drain as water is soaking underneath the garage door into the garage. The driveway has a fall, slant towards the house so I think the channel drain should be nearest to house rather then away, also what type of channel...

To the left is the extension, on the right at 90deg to this is the original house wall. To the right of the patio door is next doors garden wall, running parallel with the extension. I have removed the existing concrete slab, which was less than 150mm below dcp level. We had no issues stepping...