elite

I have an issue with a tamper alarm on my wireless external sounder. Yesterday in the middle of the day the alarm went off on the keypad whilst alarm not set. After silencing it it told me I had a tamper alarm on the external sounder. After resetting it happened again at about 9pm. I checked...

Hi - looking for advice on how to set the zones on my Texecom Premiere Elite 24 kit. 5 x PIRs, one each per zone (1 - 5), zones 6 - 8 linked out on board and also set to disabled. Zone 1 is the main hallway, keypad is in view of the PIR, zone type is Entry/Exit Zone 2 is the utility room - it's...

Hi, in order to install the above device, I need to upgrade the firmware. I bought the cable I thought was required, but can't work out how to do it. Can anyone direct me to any instructions for doing this please. I have downloaded the wintex software and would appreciate any guidance please?

Hi, hoping for some help. I've installed a prem elite 48 around a month ago with 18 devices, all hard wired using EOL (via panel, plus and 8xp, and a contact and pa via the keypad zones). All has been working great. I've just purchased an 8xp-w and 2 smart keys, but I seem to be struggling to...

Can anyone point me in the right direction as how to to program the control timers. I have got everthing set up as i require, I just want the panel to self arm at night times and turn off in the mornings on the Part Arm Zone B. I have programmed via Wintex, but all i get is Time Arming B...

Hi Everyone, I'm in the process of programming my new alarm, its a Texecom Premier Elite 48, with 32XP Expander. I've managed to get the system to learn the PIR sensors, i'm struggling with the door contact sensors (Impaq Contact-W), the control panel isn't able to find them. I've shorted the...

Hiya, I'm just getting ready for a bit of Sunday DIY but thought I would quickly check the wiring. This forum has been brilliant in getting me up to speed, but nothing wrong with a little confirmation from my peers! So... I think I've established that I can replace the Integral Timer in my...

Hey So I have been in the process of removing my Banham Euro 46 system (being a hybrid with about 30 sensors!!) and I am replacing it with the Texecom Elite 24 for endless reasons. I bench tested the system with a TMD15 and a Texecom Dual Tech detector and it worked fine! That was a few months...