hive active wiring

Hi, I have done a self install of my hive for the lp241 programmer. I have read on here that it is a like for like switch for the lp241 to the hive dual channel receiver, however I have a slight issue on the heating side. I have disconnected the previous thermostat and linked the terminals...

Hi Everyone I am hopeful someone smart on here can help me out.... I had a Nest 3rd gen learning thermostat connected to my Ideal Heat 12 System Boiler. It was flakey the entire time we had it. Google replaced the heat link once and the thermostat once in the first 12 months. This year it...

Afternoon I have just installed the hive combi boiler thermostat and wanted to see if I had done it right. From Myson touch v2 to Hive. Thank you in advance.

Hi I have an existing Drayton wall thermostat , which I need to remove as I have a Hive thermostat to install. There are the 3 wires coming from the backplate of the thermostat. live goes to bottom of 3 in the wiring centre, wire 3 on thermostat goes to bottom of 2 in wiring centre. The top...

Hi all, Sorry to add another thread but I’m looking for some help. I have installed a hive v3 water and heating replacing my old st699. This was prompted by removing the old thermostat that I thought wasnt working and doing nothing to find it was infact setting the heat of the house and plunged...

Hi i am wanting to swap the current honey will system attached to my combi boiler with a new hive one whilst I am not an expert, I am competent so believe I can swap this the same as I would a light switch or plug fitting - am I right that in the images attached, the wires would line up like...

Hi all, I’ve been looking to install Hive in a central heating system made up of: Glowworm Xtramax HE boiler Honeywell ST9100C timer Honeywell rotary thermostat (unsure model number) I’m not having much success as the wiring has me very confused. I’ve previously installed hive but never seen...

Hi, recently wired up a hive to my boiler. The receiver switches off when you turn the heating below current temperature and switches on when putting heat on or boosting. If I leave the clock on the problem is the boiler doesnt switch on or off with the hive controls so it would stay on...

Can anyone offer any help with my Hive underfloor heating in my kitchen please? I have two hive zones. One for the house and one for the UFH in the kitchen. The UFH has a separate Hive receiver next to the UFH manifold and this is triggered by a Hive thermostat in the kitchen. When I boost...

Hi all, Just get someone to double check my research into the wiring as planning to move to Hive (single channel). I have a Worcester 28i junior boiler with BR1) receiver (wall mounted - picture 1&2) & remote thermostat (BPS242RF) which is not working hence the heating system but still have...

Hi all, Thanks in advance for reading my post. I've got a gas safe engineer booked in to service my boiler and asked him how much it would cost to swap a reciever only.. Which he quoted £100 for a 5 minute job, when he's here anyway....? Could someone clarify the wiring for me please (which...

Hope you are all well. Am trying to install a hive active in my flat with a combi boiler. I have a Honeywell timer ST6100A with a frost room thermostat and a combiner's boiler 24i green star junior. The timer controls hot water and the room thermostat controls central heating. I need help wiring...