hive hive2 thermostat

Hi, I'm trying to replace a Honeywell BDR91 Thermostat with a Hive Active Heating one. The relay box for my Honeywell had wires going into the following (pic attached) N L A B I attempted to match to Hive as follows (pic attached) N L A=1 (common) B=3 (heating ON) However no power seems...

Hello, We just moved into a new house that has a Siemens therm installed on a Glow worm combi boiler. It works fine but I find it really complicated to programme so want to switch to a Hive as the prices are down for 'black Friday' sales. Before I install I just want to doublecheck the wiring...

Hi All, I am thinking of replacing my wired Honeywell programmer and dial thermostat to a Hive V2 and would be grateful if anyone can confirm a few things! I have a separate hot water tank. I have attached a few pictures of the wiring of the programmer and dial timer and labelled the photo...

Hi, I have been trying to add a new thermostat to my Saunier duval Therma Condense F 30 E. The wiring instructions with the boiler are poor to say the least. The below is all its says. Additionally I know its a zero volt switch on the terminals with the link wire shown below. This is a pic I...

This might be a bit of a challenge as I really don't know an awful lot in this field but to cut a long story short I've taken a Hive 2 (with hot water) out to Spain for a new oil fired central heating/hot water (with solar) system. Naturally enough the Spanish plumbers aren't familiar with the...

Sorry to put another Hive install thread here, but although it's obvious where the live and neutral go, I'm having difficulty identifying where the other two need to be connected. I've Googled the hell out of it, but I think the 825 being fairly new doesn't help things. Help would be extremely...

Is the hive receiver 2 channel a straight swap for honeywell 7 day 2 channel. I have 2 two port valves. A cm907 room stat with two wires coming out of it. Programmer has 4 wires. Live neutral 3 and 4 for hw and ch. So if I'm going for a swap correct me if I'm wrong, receiver is a straight...

Replacing my honeywell t45 with hive2. Honeywell has 8 connections.... Hot water - com, nc and no (3 connections) Heating - com, nc and no (3 connections) Live Neutral (Total 8 ) :cool: The hive receiver has 6... L,N,NC,NO,NCOC, NO so the hive2 is missing the com connections. Where should...