isolator

I've been trying to get around to replacing the old bathroom in-line ducted extractor fan in the loft with a new run-on version as the one up there currently is next to useless. As there is a pull cord switch next to the shower, I assumed (I know, never assume, it makes an ASS out of U and ME)...

Hi, I am fitting a double outdoor socket. The Line cable will be connected to an isolator and then to the double sockets. I have IP68 glands https://www.screwfix.com/p/tower-male-comp-gland-20mm-2-pack/80851?_requestid=738934 to fix to both boxes but I need a bit of conduit between the glands...

Hi I am installing an extractor fan that has a built-in humidstat and timer. I ordered a '10A 3 Pole Fan Isolator Switch with 3A Fuse' to combine having both a fan isolator switch and a FCU. Has anyone wired one of these up before or would they have a good idea how to do it? It's more the 'L...

I wish to have a new cooker hood installed that will come with a plug, so need a single socket installed up high. Initial idea was to use a vacant single socket above the worktop, change this to an FCU and spur a socket above or in the wall unit adjacent to where the cooker hood needs to go...

The distance between a new CU and the existing meter will be more than 2m (probably closer to 5m), do I need a trip/isolator between them?

Hi there. I've got a simple question about isolator switches like this Wylex 100A one. Their datasheet says: "It’s safer because the supply tails are fixed and finalised in a sealed unit – instead of being left hanging loose ready to connect to the meter." but their diagram shows it between...

Just got my self a Electrolux Built in combi microwave oven that has a connected load of 3000W. It is going along side my existing 3.5KW Electrolux steam oven. While a 13A BS1362 fuse will just about take this 3000W Load, the manual is ambiguous. On one hand it says; What suggests it has to...

I have an existing isolator that allows the fan to come on when the light is switched on. It needs to be replaced and have bought a new switch already but I've found that the labels on the back for the wires are slightly different. Can anyone help with which wires go where on this setup please...