low pressure

Please can someone help me I’ve lived in this property for a week and yesterday I ran out of gas, I topped it back up and since can’t get my heating back on I am trying to re pressure it but I don’t think I am turning the right things if anyone can guide me in the right direction that would be...

Hi Everyone, was just hoping for some advice regarding pressurising a boiler. I have a Vaillant Turbomax, not 100% sure exactly what model but it’s about 20 years old now. My boiler pressure has reached 0.5 Bar so I thought I should open the internal filling loop and repressurise. However when...

So I found this site while googling my problem - I can’t find any videos online that exactly match my boiler and since I know next to nothing about boilers, I don’t want to accidentally make the problem worse. My boiler is flashing a CH pressure of between 0.2-0.4, it’s been gradually getting...

I have a vented S Plan with a System Boiler stacked over the DHW Cylinder in a tight airing cupboard. The Cylinder is 1150 High and over it is a Vaillant Boiler. All is working perfectly with flow to a first floor shower just acceptable and we have plenty of stored hot water. But we are about to...

Hello all. [following is the edited version as apparently the original had too many words...]. My incoming supply is rubbish. I've looked into improving it through Thames Water and the management company of my flats, but I'm stuck with a little less than 1 bar (second floor flat), and a flow...

Hi I have an AEG dishwasher which fails with a i11, low water pressure fault, at the same point, halfway through (2 hours into a 4 hour wash) the ECO wash programme. it does this at no other time and on no other wash programme as far as I can tell. Does anyone know what is peculiar to the...

I have a 7 year old Worcester Bosch boiler (not combi). I have recently bleed radiator which has meant a loss of pressure meaning that the hot water now won't heat up. I looked up various YouTube videos and mine doesn't have the have the same filling mechanism as all of the videos watched. Some...

Hi all, Some great info on this forum. I need help repressuring an Ideal Independent Combi 30. Pressure has dipped below 1 and we have intermittent hot water that trickles out the taps. I understand that I need to turn the valves located on the flilling loop, however, I can't seem to find...

Hi there, I had to bleed one of our radiators last night due to it not getting warm for a while (and making a water rushing noise). After I did, when switching the heating back on the boiler pressure is at zero in the red, then the flow temperature on the screen goes from 25 degrees c to 99...

I have a fairly old electric water cylinder (maybe 80 litre) Im suddenly getting low pressure. Does anyone please have any idea for the possible cause ? Im thinking maybe rust is building up inside and os causing a blockage ? it doesnt have an expansion tank but I think has a pressure valve...

Hi! Please can someone give any tips on increasing the bar pressure? I can't find anything on the boiler version we have and I also can't find the loop that usually resolves this!

I have just changed my very old mixer for a Triton Pirlo thermostatic bar mixer shower (from Screwfix) but the flow/pressure is now barely acceptable. I've tried different shower heads including ones designed for low pressure systems with little improvement. The shower and hot water cylinder are...

Hello all. Been babysitting an old Baxi105e for three years and it's not a disaster but a bit temperamental. Current niggle : first time in the day, the CH side only fires up if the Hot water is run at the tap first for a few minutes. On turning the hot tap off the CH smoothly takes over and...

Hi, So i have a problem i was hoping some one here may be able to help with..My boiler as low pressure well in fact the dial is at zero...is raising the pressure something i should be able to do or should i call somebody out to look at it? The boiler as 3 Valves i can turn and the a silver metal...

I have been unable to identify the filling loop as there is no obvious external connection and I don't see any pairs of taps that I usually find on boilers. Many thanks in advance!

We've got a Potterton boiler with a hot water tank upstairs in an airing cupboard. Every year we close the valves on our radiators because they heat up even with the heating turned off. We've opened up the valves for the winter and tried bleeding the radiators but there's a lot of air in the...

I have been sent this picture of a Vaillant boiler where the pressure needle is down at the bottom. I advised my friend that it (obviously, doh!) needs re-filling and I superciliously (super-silly?) told my friend there should be something obvious on the underside... but - sadly - this picture...

We have a Baxi 105e Instant and have just had a new mixer shower fitted. The only thing we have noticed is that the pressure on this seems low. Is there anything that can be done to improve this? I don’t think pumps are compatible with combis. I think the pressure is down slightly following...

Hi, Have bought a house and inherited a Vaillant EcoMax 835/2 boiler, about 10 years old. Seemed to be working at first. However it started to give f25 faults and now alternates between f25 and f32. You can clear the fault and then it might work, but sometimes it takes 3/4 attempts. When set...

Folks, Moved to new property about two years ago, where we have Worcester Highflow 400 Electronic RSF (originally installed ~2002) and looks there are some issues and was wondering if any experts around and able to check in Aberdeen/Aberdeenshire area. Here's what's happening... * Started...