premier

Hi everyone Recently installed a Texecom Premier Elite Ricochet system, previously always fitted Galaxy panels where you can quick set by pressing A) Is there a way of enabling this on the premier panel so the user doesn’t have to enter their code to set the panel? Many thanks in advance Matt

I have an issue with a tamper alarm on my wireless external sounder. Yesterday in the middle of the day the alarm went off on the keypad whilst alarm not set. After silencing it it told me I had a tamper alarm on the external sounder. After resetting it happened again at about 9pm. I checked...

Hi, in order to install the above device, I need to upgrade the firmware. I bought the cable I thought was required, but can't work out how to do it. Can anyone direct me to any instructions for doing this please. I have downloaded the wintex software and would appreciate any guidance please?

Morning all, I put in the alarm unit about 15 years ago ish, time flies and until recently it seemed fine. Had a battery charge error, replaced the battery and (touch wood) that's gone away. I have lived all this time ignoring a constant ATS failure error message, but now we are about to...

Hi, hoping for some help. I've installed a prem elite 48 around a month ago with 18 devices, all hard wired using EOL (via panel, plus and 8xp, and a contact and pa via the keypad zones). All has been working great. I've just purchased an 8xp-w and 2 smart keys, but I seem to be struggling to...

Hi, I'm setting up a two magnetic contacts on one wired zone with a junction box and a FSL (and yes, I probably should have settled for a simpler system as I have no experience in alarm systems). Anyhow I managed to make the contact chime when commissioning. After that I played around with...

Hi all, ... First post, just want to start with some appreciation for all the information already on this forum. I have used it to setup my Premier Elite system from scratch with no alarm experience. just being a qualified electrician. I do however have 2 questions: - I have a Ricochet PA...

Hi I'm trying to integrate my current Texecom Premier 832 alarm system with Xcomfort. I can use the outputs and connect these to an Xcomfort binary module. I would like to have a pulse triggered when the events below occur. I believe I have figured out no. 1-3, but the motion trigger (also...

Hi Everyone, I'm in the process of programming my new alarm, its a Texecom Premier Elite 48, with 32XP Expander. I've managed to get the system to learn the PIR sensors, i'm struggling with the door contact sensors (Impaq Contact-W), the control panel isn't able to find them. I've shorted the...

I have been attempting to use a Texecom Premier 816/416 keypad output to control a light inside my garage. I have a Premier LCD/LCDL keypad and the garage zone is mimic'd to the keypad's output and lights an attached LED for perhaps a second. However any adjustment of the "Output Short Pulse...