renovation concern

  1. N

    Removing section of airing cupboard

    Hello all, Long time lurker and recently new home owner. We are renovating our bathroom and looking to gain some space/square off the bathroom (1st floor). We currently have an airing cupboard that is position halfway into the bathroom, now were looking to remove the section that protrudes...
  2. M

    RSJ Bearing question - do I need to fix?

    Looking for some input (help) guys. Padstone is 80mm in depth. RSJ has been installed to sit on the concrete pad and bricked in on the inner leaf of the cavity wall. RSJ - 2 * 203 x 133 UB RSJ open span - 4.3m Note: also has a point load from additional beam in centre (additional beam 2.2m)...
  3. W

    Damp

    Any advice on the below? We are renovating our house and found a very damp inside corner of an external wall, where the original wall of the house was knocked through to a single storey extension. You can see in the photo the wider footing of the house. Our builder thinks this is because the...
  4. J

    RSJ Spacers - Are they needed?

    Guys, Any advice.. SE specified bolts and spacers necessary. Builder has added bolts but not spacers. The work is up and he is saying spacers are not needed and is pushing back (basically refusing) on making changes now. The beams sit right next to each other - no space in between - is it...
  5. J

    RSJ Spacers - Are they needed?

    Guys, Any advice.. SE specified bolts and spacers necessary. Builder has added bolts but not spacers. The work is up and he is saying spacers are not needed and is pushing back (basically refusing) on making changes now. The beams sit right next to each other - no space in between - is it...
  6. D

    is RSJ correctly supported?

    Guys, I have a builder in doing some work for me. He put up an RSJ where there was previously a load bearing wall. Can you comment on the photos? I'm not 100% confident in what's been done. New RSJ spans 5 metres and also supports smaller pre-existing RSJ. Areas of concern, - Pad stone 80mm...
  7. G

    Help lights not working, sockets tripping, TV coming on - new wiring...

    Hello Problem - No lights or sockets to the back of house RCD resets momentarily and then another switch goes. Sockets now now sensitised (no more tumble drier or hoover). its pot lock if it resets and we are leaving the lighting one off as nothing resets if that remains on. Context - We are...
Back
Top