sink fitting

Looking for some advice - having my kitchen redone and the b and q plan shows this cut of the worktop. The sink is as shown. The fitter didn’t look at the sink until after they cut the worktop and then told me I can’t have my sink (or any sink more than 780mm). I can’t find any standard bowl...

I just spent the whole day replacing my kitchen sink and taps. I have a new mixer that I cannot get to stand straight. It's leaning slightly to the right, and wobbles a lot even though the sink is 0.9 gauge steel. There is a C-shaped plate under the sink holding the tap in place with rubber...

Hi all, Had a new sink fitted, kept the tap in the same place but now have the draining board on the right hand side. The socket and fused switch are horizontally less than 30cm from edge of draining board. I assume it's now against regulations? If so, can the fused switch comply with...

We are in the process of installing a new kitchen, and we've hit a problem with the sink. Everything has been replaced, so it's new units & worktops with a 1.5 bowl ceramic top mount sink which has replaced a metal 1 bowl sink. We bought a new waste to fit the 1.5 bowl but when we fitted it...

hi, Ive got a smallish ikea stainless steel sink with no tap hole. Ive watched a couple of vids recommending a step bit and wd40 to lubricate it. Do I need to mount the sink in the worktop first to support it ? im just thinking that the worktop will be thin at the back once cut out for the sink...