sms

  1. D

    Remote control of heating without Nest/Hive or similar

    Sorry this is so long! Situation: I'm often away from home for a week or more, and want to be able to switch the heating on before I return - but I don't want to go the full Nest/Hive etc or rely on a third-party service. My last place had a combi gas boiler which fired on demand, if either...
  2. eveares

    Pyronix Enforcer Panel - SMS call Fail

    The other day for the first time in 4 years, my Pyronix Enforcer Home Control+ panel started beeping and went into a fault condition for the first time under a normal idle state. The error what I believe caused the "fault condition" was a "SMS call Fail" event, although not sure why it...
  3. J

    Agility 3 Follow Me

    Hi I have installed an Agility 3 panel at my home, with GSM and IP modules added. I am having trouble getting the SMS notifications to work. I have correctly set up the follow me number, type and events. I have also set the GSM message centre number (I am using a TESCO mobile PAYG sim) I...
  4. greg_0ry

    Pyronix Enforcer Wireless Alarm System - GSM-KIT-1 (Line fault)

    I have installed the GSM-Kit-1 and everything is working as expected except the SMS part. I purchased a GiffGaff SIM card with £10 Top-UP and run through the setup like the one below: Programme Arc/SMS (response yes) Programme Arc/SMS calls (response yes) Arc/SMS is enabled (response yes) Arc...
  5. G

    Pyronix Enforcer questions

    Hi All Just fitted my Pyronix Enforcer and all went well (well except a shock when i pulled the tamper wire out of the bell box whilst standing on my roof! anyway...) I have a few questions 1. The Pet friendly PIR's seem to not flash very often at all, in fact I can walk from the front to the...
  6. T

    Galaxy flex 20 v3 SMS user notification

    Hi all - I have just installed the above panel with the AO81 GPRS/GSM module. I can send text messages to the alarm to activate etc and it works, and it will respond with the alarm status. However I can't get it to send a message when the alarm goes off. I have followed the steps in p 147 of...
  7. M

    CHC SMS Gateway call, Pyronix Enforcer quesition

    I have it all working. setting 6, gives me the notification sms message alarm has "gone off" my question is the panel calls a number to check the CHC / sms gateway number once a month. i read somewhere you can deactivate /disable this, dont wanna be paying premuim rate numbers as often. I...
Back
Top