trim

I want to put some trim along the top of tuis stringer, but this part has 3 sections and it would look better and be easier if I reduced it to two sections. Is it safe to trim the part above the green tape off the top of the stringer? It would be up to 8mm at most.

Planning to tile halfway up my kitchen window, I want to tile inside the recess but how to negotiate the external corner has me stumped. Absolutely cannot find any such thing as a bullnose mexican tile in the UK and I feel like a metal or plastic trim would ruin the handmade aesthetic... How to...

Hi there - I am new to the channel. Wanted to run a question by some of you experts out there. I am replacing windows in my home with replacement windows and am trying to figure out the best way to put trim on the exterior. As a side note, my neighbor hired a contractor to install his windows...

I have very deep window sills in the bathroom, (450mm deep) and I want to put LVT golden oak on them. The walls and reveals are painted, and there is no bullnose or overhang at all. So it's just the depth of the lvt on the front flush edge that will need disguising. Unless I cut a 25mm strip and...

Our guest bathroom shower enclosure has six transparent seals for the doors - two of which have discoloured/yellowed (same part - from both sides). Before we look at replacing them, does anyone have any tips for restoring discoloured/yellowed trim back to its transparent state?

Amazing how the prospect of moving house gives focus to lots of little jobs that I had somehow been avoiding... :rolleyes: She Who Must Be Obeyed has pointed out that it would be nice not to have a blatant crack in a floor tile when showing people round (and the grouting is crumbling too), but...

Am putting in 18mm ply with 8mm click vinyl surface, looking for an 8mm edge trim to go along the btm of this sliding door, just under the window frame btm, it's a bit tight for clearance at the right hand end but gets better to the left. Reveal is 2525 skim to skim. There is a 2.5m Dial 8mm...

What is this molding called and where can I buy it ? .... or is it more likely to be a bespoke creation ? - each block is about 1 inch in size. Any thoughts gratefully received

I haven't used this panelling before, haven't done much tiing either. Shower panels look like the way forward if I can get some for above the bath. Does anyone supply custom panels? (probably not laminate). Thick enough to be rigid. For walls above long side and each end. Approx.160cm tall...

Is it normal to have gaps like this on the trim on the outside of the windows?

hi, What sort of strip is best to join a slightly higher tiled floor with a tile edge strip that is partially broken to a laminate as in pic ? Thanks

I have some floor trim/beading to go around my new laminate floor, but I'm struggling to get a nice 45° degree angle. I have a mitre saw which has 45° setting but the trim is not flat so I can't get the angle to be flush. Skotia edge by barnsley7 posted 8 Dec 2019 at 3:18 PM Skotia trim by...

We have a sliding patio door which I have looked all over and cannot find any kind of branding. The doorstep trim (see photo) is very tatty. It a black plastic section which clips into some aluminium track underneath. I have spent most of the morning Googling and cannot find anything similar...

just replaced a defective pentangle shower tray with a stone resin quadrant tray 1000x1000mm (radius 550mm). The old tray was fitted butted against the tiles (which went to the floor), and not underneath them, so it leaked. I have cut away tiles so that new tray slides underneath. I now have to...