tumble dryer

Hi, I'd like to connect my washing machine and condensing dyer to the same standpipe. I've seen this McAlpine Twin Hose Connector. The washing machine hose would connect perfectly to that but the dryer hose is only 10mm. Does anyone know of a 10mm to 20mm adapter I could use, or suggest another...

hi all, yesterday eve our IDV75 tumble dryer tripped the electrics. when I opened it there was a strong smell of [electrical?] burning so I turned off the plug and left the consumer unit switch off (it's on a separate circuit in the garage). when I tested this morning it seemed to be working...

Hi, i have a Creda Debonair Compact tumble dryer model 37305. It is a few decades old, but has worked fine until this week and it fits the space we have so don’t want to scrap it just yet. When I rotate the timer knob to switch it on, there is a kind of buzzing noise but no rotation. Hot air...

Hi, looking for some help, I have a Bosch Classix 7 tumble dryer model WTE84106GB/48 and recently I noticed that no condensate is being collected in the drawer. Otherwise it appears to work but presumably isn’t drying as quickly or as efficiently as before. The dryer is almost 5 years old now...

Hello everyone. We’ve had our Hoover Tumble Dryer for little over 3 years now, and with 2 small kids it gets quite a bit of use as you can imagine. Recently I had noticed that the machine wasn’t drying clothes as effectively as it usually did and planned to give the condenser a good clean...

Hi, I have a Zanussi ZDC8202P Lindo 300 Condenser Tumble Dryer that turns on OK, but when you press the 'Pause/Start' button, the machine beeps 3 times and the 'Pause/Start' light flashes red. It has done this previously, and after a good clean, has worked again. This time, however, that is not...

I've not long had a new Beko vented Tumble dryer and couldn't understand why I was getting static electric shocks as I was pulling out the clothes after drying but now I think I find the cause. Although the metal cabinet on the tumble dryer is earthed (I tested to the earth pin on the 13a plug...

Hi in our garage we've 2 double sockets i think the previous owner has added the socket on the right. We've noticed when taking the tumble dryer plug out of the socket on the right the pins are red hot!!! which has us worried. If we put the tumble dryer in the socket on the left its fine...

Hi all. Following on from my washing machine fix (Beko carbon brushes) the Indesit IDV65 tumble dryer is struggling to turn (certainly on higher loads). I've actually just changed the heating element and thermostat as the old one was on the way out, but conscious that since I swapped this last...

My condenser dryer isn’t working- when I press the start button it beeps 3 times and flashes continuous red and won’t start. It has done this intermittently in the past but then worked again but now it definitely seems to have given up the ghost. I have run the diagnostic test and it flashed red...

Hi. This stopped working today and I'm after some advice. Checked the thermostat and have continuity. Checked the NTC and the resistance decreases when the probe gets warm. Pulled the plug for the heater from the PCB on the front of the machine and have no resistance on one of the...

Hi Just wondered if it would be safe to place a vented tumble dryer (the hose comes out the front of door) under a combi boiler, in an outside cupboard? I'm tight on space & just want to know if I can do this (would run the hose outside when in use)? I live in a flat & the front door opens...

Hi all my partners parents have given us there old white knight tumble dryer which we've put in the garage.The only problem is there appears to be a small leak on the underneath on the right side. It's drying our clothes fine just wondered if anyone had any ideas what I should look out for if I...

Hi - got a Beko Condenser Tumble dryer not heating. Took back off which covers the heater , load of dust and fluff around the heating elements - removed all that. there are 2 cut out safety devices at top of heater bottom cut out device is re-settable , pushed the reset pin in and got a...

Hi All, can you help? My tumble dryer water container isn't collecting all of the water from the machine therefore water is pooling in the chamber. Any ideas as to why this is happening and what I can do about it? Many thanks. Nick

I got given a rather good miele tumble dryer model T7934 - The previous owner was "upgrading" to a integrated heat pump variety. The problem was, they did not really look after this thing properly. They rarely cleaned the lint filter or checked/cleaned the seals. This resulted in dust making...

Hi, I've recently bought a second-hand Miele T8966WP EcoComfort heat pump tumble dryer which is ending programmes a little early saying "Clean out airways". I've cleaned the fluff & fine filters in the door and the same in the door opening, and the fine filter in front of the heat exchanger...

The waste pipe on this tumble dryer is especially small diameter. No problem as it comes with an adapter which you put into the compression fitting - see this video; However; what do you do if you have an existing washing machine waste hose and you need to connect two hoses? I don't have room...

Hi all. I'm attempting to replace a belt in my Indesit IDV65 tumble dryer (and also the bearing - possibly related to the belt snapping as I replaced the original bearing a year or so ago). I've taken it apart to double check it was the belt (it was - snapped) but also for a trial run so when I...

Hi All, I have a Caple Tdi 110 integrated tumble dryer. The three arm spider bracket which mounts the bearing to the drum has broken and I've managed to remove it by drilling out the 3 retaining rivets. The problem is I'm unable to locate a replacement spider bracket. Has anyone else had this...