waste pipe

  1. I

    Washing machine and dryer to single standpipe

    Hi, I'd like to connect my washing machine and condensing dyer to the same standpipe. I've seen this McAlpine Twin Hose Connector. The washing machine hose would connect perfectly to that but the dryer hose is only 10mm. Does anyone know of a 10mm to 20mm adapter I could use, or suggest another...
  2. M

    Saniflow or wastepipe

    Hi, I'm looking for advice on the classic saniflow Vs standard toilet issue. We're looking at getting an understairs toilet fitted in our house. We've had 5 people round to quote for it and all but one suggested we use a saniflow to go under the kitchen cupboards and out to the soil stack. The...
  3. P

    Toilet smells

    Hi. Started getting some nasty smells in the bathroom. I think they're coming from the toilet plumbing. Does this look right? At first I thought that the flexible connector/pipe had come loose from the hard grey soil pipe it joins on to. I thought that I had to jam it on to provide a tight...
  4. A

    cutting a shower door

    Hi, I have a small space (1200x2800) for a bathroom. the back of the room (on the external wall) will be taken up with a shower and shower screen (The ones with the left side static and the right side slides open). I need to get the waste pipe from the toilet through the external wall to connect...
  5. S

    Waste pipe through floor - best approach?

    With reference to the photos, I have solvent weld pipe coming out of the floor and need to adjust it as it is too far from the wall and will foul on the new units. Previously, they just hacked the units to get the pipework to fit! First question is whether I should just move the pipe and bring...
  6. D

    Hopper overflowing

    Hi First time poster here after some advice. I’ve noticed the hopper is overflowing when there is a high flow rate. The pipe going into is from the bathroom basin. At a low flow rate it is fine however at a fast rate, the water flows/spills over the side of the hopper. What is the best way...
  7. E

    Granny Annexe

    We are looking to put a granny annexe next to our home. Except our garden is 15 feet below the main home as it’s on a hill. So it would be against the retaining wall. Main main question is waste as the mainpipe would be well above headheight at the main house. Is this possible?
  8. J

    Washing machine pump waste

    Hello Installing washing machine in remote location under stairs/ no drain near by here’s what I’m proposing but never done before so thought I’d have an ask, Fit washing machine with hose into hockey stick trap then connect to Grundfos sololift C-3 lifting station, core through the wall to...
  9. AdFromEssex

    What sort of drain is this?

    Hello again, On changing the bathroom suite, I have found the bath drains in to this hole, with the sink draining into a similar hole beside it that leads to the same drain. The bath waste pipe came out with ease, which leads me to worry that the bathroom floor could flood in the event the...
  10. D

    New Bathroom - Drainage, Pipes, is this plan good?

    Hello I am about to start my tiling in my upstairs bathroom which I delayed from last year. I just made a quick sketch of my drainage plan. Please see below, is it all good for Uk Regs. My Building Officer told me that it is best to use 50mm. then connect your 40mm pipes to it. Using riding...
  11. Ronsil82

    Using a shower base as a washing machine waste?!?

    Hi all, I wonder if anyone can offer some help. We have an old shower at the back of the house and would like to put the washing machine in there. The shower base raised and I wondered if it is possible to use the shower drain as the washing machine waste. I would want to run the waste pipe...
  12. L

    Waste pipe flowing wrong direction?

    Hi guys, So I’m desperately after some advice! Since moving into our house a few years ago the sewer pipes always get blocked. We’ve had professionals clean them but they still clog up after a few months. What I believe to be happening is my waste pipes are not on a steep enough gradient and/or...
  13. C

    push fit or compression fittings for waste pipe

    Hi quick question I used two 90 push fits bends to connect the 40mm waste to down pipe. Now when every hot water goes down it makes a knocking/creaking noise that is driving me mad. Guessing it is from heat expansion. Do compression joins have the same problem? As I was just thinking of...
  14. R

    Soil pipe mayhem

    Hi All We are buying our first property and have what we suspect is an exposed 4" soil pipe running along the kitchen ceiling. The pipe has been boxed in and it's there as a result of an extension. What possibilities are available to fully conceal the pipe or redirect it? We have attached a...
  15. M

    Shower/Bathtub waste into ground

    Hi All we just discovered that our shower and bathtub waste is going to a small pipe that does not appear to be connected to the main sewer... this was all discovered by chance as we recently moved into the property and I was working on the front garden, it looks like the previous owners have...
  16. B

    Connect to bend of soil pipe

    I HAVE already installed the soil pipe in the concrete slab. I have NOT yes put the insulation or screed. As a last minute change I now want to put a wet room in the room immediately next to a toilet room. Ideally what I waned to do was to connect the drain from the wetroom into the soil pipe...
  17. robodelfy

    Soil stack mistake, any solution?

    Hi, I'm doing my soil stack, but having to attach it 13cm away from the house to leave space for external wall insulation which I'm having done in a few months. I thought I was doing well! For the two runs of 40mm waste, I intended to use two 135° bends to get the 40mm pipe closer to the wall...
  18. D

    Free standing bath

    Hello, I don’t really know anything about plumbing so not sure if anything I’m describing makes sense. I’ve just got a new freestanding bath delivered and it’s currently in the bathroom sitting on top of 2 planks of wood waiting to have the waste connected. I’ve got a 40mm compression elbow...
  19. I

    38mm European waste pipe to 40mm UK compression waste fitting

    What's the best way to ensure a watertight fit connecting a 38mm European / continental waste pipe to a 40mm UK compression waste fitting without using a 38mm to 40mm adaptor prior? The reason not to use an adaptor is because there is no space. Note, a 40mm compression fitting on a 38mm pipe...
  20. D

    Grey water in shed

    Hey All, I am building a concrete block shed with an outdoor (roofed with bifold doors in front) kitchen. I want to have there gas bbq, small gas hob, both connected to the same gas bottle, and a little sink. That way i can spend more time outside and cook there. I would use sink to wash hands...
Back
Top