- Joined
- 5 Nov 2015
- Messages
- 1
- Reaction score
- 0
- Country
Hi
I'm doing the prep work for a shower room at the moment. The room was fully tiled before and on removal of the tiles I found they had all pulled away from the wall and hardly attached at all. The wall behind is block work with plaster skim on top.
So I'm left with a patchy and dusty skim coat which doesn't seem up to the job of holding some potentially heavy tiles.
I suspect the average diyer would blob some Pva about and tile it up but I suspect that's what caused this mess last time!
My plan at the moment is to apply some kind of backer board which is both insulating and water proof and hang the tiles on top.
I'm looking at a product called Jackoboard. Has anyone got any experience with this stuff and does my plan sound ok? It's not going to be a wet room floor as I intend to install a shower tray but I'd rather go overkill than end up with water where it shouldn't be.
Thanks
I'm doing the prep work for a shower room at the moment. The room was fully tiled before and on removal of the tiles I found they had all pulled away from the wall and hardly attached at all. The wall behind is block work with plaster skim on top.
So I'm left with a patchy and dusty skim coat which doesn't seem up to the job of holding some potentially heavy tiles.
I suspect the average diyer would blob some Pva about and tile it up but I suspect that's what caused this mess last time!
My plan at the moment is to apply some kind of backer board which is both insulating and water proof and hang the tiles on top.
I'm looking at a product called Jackoboard. Has anyone got any experience with this stuff and does my plan sound ok? It's not going to be a wet room floor as I intend to install a shower tray but I'd rather go overkill than end up with water where it shouldn't be.
Thanks