If a 600 deep (30thk) worktop or sit-on sink have a roll front, then this means that they actually measure up as 615 deep, because of the radius, right?
Thank you,
Dain
Thank you,
Dain
Are roll front and square edge worktops different depths?
Worktops can be anything from 10 - 50 mm deep, a width dimension at 600mm are just that whatever the edge finish.
I just found a scrap piece of roll top worktop, 30thk and 615 deep?
You mean 615mm wide? yes thats one of the many available sizes.
but a 600 roll top sit on sink would be 600 INCLUDING front edge radius?
I suppose a 615 worktop would accommodate cutting the back edge to fit an odd shaped wall?
Yes, comes in variety of sizes, better quality tops are 660-670 wide to allow for wonky walls.