I have a TC7103W Zanussi drier that is 16 yrs old and has worked ok until recently when it started dripping water. I could see at the back of the condenser unit that it was fairly gunged up so after watching utube videos I took the back heater and dust channel cover off. The panel was stuck and took some shifting. Some of the seal came away. Looked on e-spares and a new one is £53!! As only about 8 inches of the seal broke off could I use some sealant on it to ensure a good fit on reassembly? The muck under the cover was unbelievable and am still trying to clean it up. Any advice would be welcome.
Back heater cover door seal on zanussi condensing drier
- Thread starter pandaman
- Start date
Thanks for that. Have cleaned all the gunk out, what a job that was. Stuck the seal bit that had come off back on with glue. Have used drier once since with a clothes wash but leaking tended to occur with sheets or towels dry. Doing a towel wash today so will see what happens. If it still drips then as you say it may be time for a replacement.