bell 801 wiring help please!

S

smogglet

Joined
18 Mar 2016
Messages
5
Reaction score
0
Country
United Kingdom
Hi I am trying to replace a entel 300 door entry telephone with a bell 801 entry telephone I bought from amazon the wiring for the entel 300 is below
10v orange + white
0v white + orange
C1 white +blue
C2 blue + white

On the bell 801 it has markings I R O T Z I have no idea which wire goes were I have tried a few combinations but no luck :(

Any help greatly appreciated

Thanks
Smogglet
 
Nope no manual just the handset and the box [GALLERY=media, 97392]20160318_094223 by smogglet posted 18 Mar 2016 at 1:25 PM[/GALLERY]
 
Last edited:
Do you mean you have just bought a new handset and not a new door panel?

Does my link tell you what you want to know?

I can't find a diagram for the old system.
 
Yeah I have only bought a new handset the picture is hiw my old handset was wired can't figure out how to connect the new bell 801 handset :(
 
They may not be compatible.

As said, I can't find diagrams for the old system.
Did find this
upload_2016-3-18_14-34-58.png

Different than yours.
 
Doesn't look like it's going to be compatible to me.
(Why are you replacing it?)
 
Ok iv looked and I'm going to order a TYNETEC ZFT 210 it says it's a replacement for entel 300 and has same connections so will hopefully work, and send the bell 801 back to amazon for a refund. I am replacing it becouse the switch is broken so when u lift and put down the phone it doesn't do anything can't accept calls think it was tampered with by previous tenants
 
Are you sure the switch is broken ? The Tyne tec handsets do suffer if the front is not clipped on fully !
 
You must log in or register to reply here.
Back
Top