Hi, would be grateful for any advice on a vertical radiator. It remains warm just along the bottom. There is a water rush when the heating goes on was professionally installed 2 years ago and worked fine last winter. Cant see any way of bleeding the radiator have taken a photo at the top of the radiator that may have something to do with bleeding the radiator? Any possible ideas or suggestions would be appreciated.
Bleeding vertical radiator
- Thread starter Phil0506
- Start date
-
- Tags
- bleed radiator
Yup, that's the bleed screw. Bleed key and loosen, keep open till all air is out, close again (not too tight), job's a guddun'
Photo is not clear.
But, you should need either a vent key or a flat blade screwdriver.
But, you should need either a vent key or a flat blade screwdriver.
Now go and check that there is sufficient boiler pressure (when boiler is cold)