Cable to old Satellite dish

WelshChris

WelshChris

Joined
20 Dec 2021
Messages
4
Reaction score
0
Location
London
Country
United Kingdom
Hi,

First time posting, but long time lurker and picked up lots of great advice. :)

I’ve recently bought a 2nd floor flat where there’s been loads of different phone, satellite and internet suppliers over the years, so lots of (now) unnecessary wires. A coxial cable runs through my bedroom wall to an unused rusty satellite dish and the cable is quite securely attached with a sealant outside so I can’t push the cable through. Am I okay to cut back the cable and filler over it? The cable is “dead” and it’s impractical to get someone in to look at something 3 stories high? Just wondered if there’s any advice or alternative suggestions.

Cheers
Chris
 
winston1 said:
I wouldn’t. I’d connect a satellite receiver to it and see what I could receive.
Click to expand...
Possibly terminate the cable with an: ae235.jpeg
So the options there in the future?
 
Thanks for the advice both! :)

I cut pack the cable so far that its “inside” the external wall and will filler over it. I’m not likely to use the dish and live in an area with good fibre internet so I stream from that, so decided against the socket (that and I’d cut it before seeing that reply!)

The obsessive in me wishes I could cleanly push through the wires and remove the dish too but it’s not worth the hassle.

Thanks again!
 
you might be able to push it deeper in to the hole with something like the blunt end of a pencil to then allow a covering of filler
 
If the hole isnt much larger than the cable it would be posible to drill part of it out to give a deeper fill, it may even push it further back a little even if it didn't remove some
 
Last edited:
You must log in or register to reply here.
Back
Top