Can this kitchen top be repaired?

M

ManniMannsta

Joined
24 Nov 2020
Messages
2
Reaction score
0
Country
United Kingdom
Hi guys,

Apologies if this is in the wrong section, is there any way to repair the laminate on this damaged wooden kitchen top? It looks like the laminate has been melted off from the hob exposing the wood underneath.

[GALLERY=media, 105586]Damaged kitchen top by Kyle Mann posted 24 Nov 2020 at 11:23 PM[/GALLERY]

Any advice is very much appreciated, cheers.
 
is it laminate or is it wood?

Look at the cut ends and the underside.
 
From the picture it looks like a real wood worktop which may have been stained or varnished.
If this is the case then you should be able to strip it back to bare wood and re-finish the surface with stain but I would recommend an oil finish. To prevent damage from hot pans etc position a heat proof mat next to the hob to put hot pans/dishes on.
 
conny said:
From the picture it looks like a real wood worktop which may have been stained or varnished.
If this is the case then you should be able to strip it back to bare wood and re-finish the surface with stain but I would recommend an oil finish. To prevent damage from hot pans etc position a heat proof mat next to the hob to put hot pans/dishes on.
Click to expand...
OP said it was laminate?
 
foxhole said:
OP said it was laminate?
Click to expand...

Agree that is what the OP stated it was but you can see the bare pattern under the 'laminate' which suggests it 'could' be real wood and not laminate.
My experience of burnt or heat damaged laminate has resulted in bubbles in the laminate or scorch marks which don't seem to be apparent here.
As suggested earlier he needs to look underneath or at the end grain if it's visible to confirm what the substrata actually is.
 
Last edited:
Hi guys, sorry for the confusion, I'm at noob with this area so apologies for the conflicting terms in my post, this is the end of the kitchen top:

[GALLERY=media, 105597]Kitchen top end by ManniMannsta posted 26 Nov 2020 at 7:32 PM[/GALLERY]

Would I be correct in thinking that this worktop is in fact wood and not laminate?

Cheers for the help guys,
Kyle.
 
ManniMannsta said:
Hi guys, sorry for the confusion, I'm at noob with this area so apologies for the conflicting terms in my post, this is the end of the kitchen top:

[GALLERY=media, 105597]Kitchen top end by ManniMannsta posted 26 Nov 2020 at 7:32 PM[/GALLERY]

Would I be correct in thinking that this worktop is in fact wood and not laminate?

Cheers for the help guys,
Kyle.
Click to expand...
Yes, its Oak.
 
Last edited:
It looks to me like it has been varnished rather than oiled. You will need to sand down the whole worktop and re varnish or oil.
 
Rub whole top down to 150, then three coats of Osmo Top oil, one coat a day over three days or at least 12 hours between coats. very lightly denied between each coat. Then use heat mats or trivets.
 
You must log in or register to reply here.
Back
Top