hi there, the cold water feed pipe on my dishwasher is angled at 45 and means the pipe can only exit to the right hand side of the machine. Unfortunately my supply tap is on the LEFT. I need the machine to go hard against the wall as it is 60cm deep so the pipes have to remain in the space at the bottom, and i dont really want to fit an extension feed pipe so that the pipe loops back on itself. The plastic bracket where the pipe goes inside the machine unclips fairly easily, but it doesnt LOOK like there is anything you can do to rotate the bracket 180, which is what i would like to do..
Has anyone done this?
thanks
Mark
Has anyone done this?
thanks
Mark