Hi all.
As the title says, I'm trying to find out if it's possible to get something along these lines using a grid system to replace an existing external setup. I would rather have a black/Dark Grey unit instead of the usual light grey if possible and I've found an enclosure that "fits the bill" HERE. It says it accepts grid modules but the manufacturers associated modules don't include a switched 1G socket. All the modules are available from another manufacturer, namely a switched 13A single socket, a fuse module & a 20A DP switch but I cannot find out if that manufacturers range will fit inside the weatherproof enclosure. Are these fittings governed by a single standard perchance? I.e. they will fit as long as the mounting holes for the yolks/plates are the standard spacings ?
Also, can the separate modules be fitted touching one another in a 4G faceplate or should they ideally have a strip of the faceplate between each module, in which case can faceplates be sourced that have one 2G opening (for the 13A socket module) and 2 X 1G openings (for the DP switch and Fuse Module ?
TIA for any advice offered.
As the title says, I'm trying to find out if it's possible to get something along these lines using a grid system to replace an existing external setup. I would rather have a black/Dark Grey unit instead of the usual light grey if possible and I've found an enclosure that "fits the bill" HERE. It says it accepts grid modules but the manufacturers associated modules don't include a switched 1G socket. All the modules are available from another manufacturer, namely a switched 13A single socket, a fuse module & a 20A DP switch but I cannot find out if that manufacturers range will fit inside the weatherproof enclosure. Are these fittings governed by a single standard perchance? I.e. they will fit as long as the mounting holes for the yolks/plates are the standard spacings ?
Also, can the separate modules be fitted touching one another in a 4G faceplate or should they ideally have a strip of the faceplate between each module, in which case can faceplates be sourced that have one 2G opening (for the 13A socket module) and 2 X 1G openings (for the DP switch and Fuse Module ?
TIA for any advice offered.
I'll see if there's a switched 1G socket available and I'll be sorted 
. I really don't want to go down the two enclosure route if I can help it so wish me luck 
. Seems to be the story of my life this, wanting things that aren't available