Recently moved home into a place with newly renovated dot and dab walls. The hammer action on my old Bosch corded drill doesn't seem to be working anymore. Took me ages to drill a hole. So I started using my SDS drill, but getting cracks on plaster and holes too big etc, even on slow setting. Is it that using an SDS is like using a sledgehammer to hammer a nail? Is an SDS drill big time overkill and shouldn't be used on normal every day drilling? And how would I know that my old drill has definitely drilled its last? Any advice?
Drill Overkill?
- Thread starter jonnyraine
- Start date
- Joined
- 28 Jul 2014
- Messages
- 1,968
- Reaction score
- 561
- Country
No, not really, I use an SDS on thermalite blocks sometimes at work, when speed is of the essence and making noise doesn't matter. Sounds more like you could do with some new, good quality bits. Get a Heller Bionic SDS bit or a Dewalt Extreme 2 SDS and try again.
Percussive hammer drills, IMHO, are completely pointless. Some really nice bits (the bullet ones)...
https://www.ebay.co.uk/itm/232741048981
...will go through pretty much anything, even hard, really old red brick, without using the hammer function. Ideally in a drill with a high RPM. I am yet to find a wall where a percussive hammer drilll works better than those bits above on non hammer. If they can't drill it, then it's SDS time regardless, hence why I say they are pointless.
- Joined
- 28 Jul 2014
- Messages
- 1,968
- Reaction score
- 561
- Country
Oh, and I'm surprised you can crack plaster on what can only be a thin skim. Put the drill on non-SDS to go through the skim and plasterboard, then switch on the rotary hammer function when you meet either the adhesive dot or the actual brickwork.
Thanks rsgaz. It's quite a new SDS - in fact never used the bits before (only the chisel) so I wouldn't have thought it'd be a problem with them. I'll try non-SDS through the plasterboard
You did turn the rotation stop off?
