Hi
Can anyone help.
Lived here for 7 years, hot water pressure all over the house has
always been fine but to the shower in the ensuite it's always been low (cold pressure is fine).
Last couple of days the shower has only run cold, have took the shower off the wall (aqualisa aquarium mixer) and there is almost no hot water coming through the pipe.
Have attached picture of cylinder cupboard, the pipes on the top right going through the wall feed into the shower literally on the other side of that wall, hot is nearest to the camera.
Have read fitting instructions for shower and it says hot water feed should be either off the cylinder outlet or below the T where it joins the vent but clearly it's not? Pressure has not always been this bad, sometimes very early in the morning it's been half decent.
Any ideas? System is gravity fed i believe it's called and the f and e tank in the loft is half full, ball cock working fine.
Thanks in advance for any help.
Adam
Can anyone help.
Lived here for 7 years, hot water pressure all over the house has
always been fine but to the shower in the ensuite it's always been low (cold pressure is fine).
Last couple of days the shower has only run cold, have took the shower off the wall (aqualisa aquarium mixer) and there is almost no hot water coming through the pipe.
Have attached picture of cylinder cupboard, the pipes on the top right going through the wall feed into the shower literally on the other side of that wall, hot is nearest to the camera.
Have read fitting instructions for shower and it says hot water feed should be either off the cylinder outlet or below the T where it joins the vent but clearly it's not? Pressure has not always been this bad, sometimes very early in the morning it's been half decent.
Any ideas? System is gravity fed i believe it's called and the f and e tank in the loft is half full, ball cock working fine.
Thanks in advance for any help.
Adam