Hi, My Galaxy G16+ has been giving me problems for too long now, & I have decided to replace it with a Honeywell Accenta G4. My question is, will my existing ADT alarm/strobe work with the new alarm?
Thanks.
Thanks.
Honeywell Accenta Mini Gen4 Wired Alarm Control Unit
- Thread starter SMG
- Start date
Yes
Thank You.
- Joined
- 19 Dec 2019
- Messages
- 184
- Reaction score
- 29
- Country
Sorry to resurrect an old thread. I was just wondering….Is it the alarm panel that dictates how the LEDs in the bell box flash or are they set to flash in a particular way on the box itself?
Or is the panel just supplying power?
I don’t want them to flash differently to how they should be on an adt box.
Thankyou.
Or is the panel just supplying power?
I don’t want them to flash differently to how they should be on an adt box.
Thankyou.
Different bell box LED's can mean different things. Eg some flash to indicate a tamper fault on that bell box, some are just comfort LED.
- Joined
- 19 Dec 2019
- Messages
- 184
- Reaction score
- 29
- Country
Thankyou.
I know what you mean about different states of flashing. I just wondered if the flashing circuits are in the box or done by the panel.
For example if I have an ADT box that flashed comfort LEDs but when hooked up to a new different panel then the panel makes the lights flash differently then it would look wrong.
Hopefully that makes sense? Sorry I’m not describing very well.
LED's will flash dependent on manufacturer, you are connecting a 12 volt power source to that bell box via a alarm control panel.
The control panel will send bell trigger, strobe trigger and tamper ,if control panel is connected to the bell box correctly.
Just connecting power will make the LED's flash only.
What are you wanting to do with this bell box?
Are you installing new alarm system or just want LED's to flash?
Just connecting power will make the LED's flash only.
What are you wanting to do with this bell box?
Are you installing new alarm system or just want LED's to flash?