Honeywell ADE Gen4 alarm system

[Robgor]

I have a problem on my Honeywell ADE Gen4 alarm system panel.
Standing fault "Hall wirls supervn F1". I'm noy sure if the sensor in my hall is faulty?

 

[sparkymarka]

A ….It’s not a Honeywell system ….it’s either a euro 46 with wireless expander or enforcer with a keypad ….
B….the battery is probably flat in the hall sensor

 

[Robgor]

A ….It’s not a Honeywell system ….it’s either a euro 46 with wireless expander or enforcer with a keypad ….
B….the battery is probably flat in the hall sensor

Thanks for responding. The manual that was supplied with the system is Honeywell, so that's a bit odd. See attachment.
All sensor batteries were replaced a week ago, as were the external alarm sounder batteries. Two batteries in in each paralleled for longevity.
It's possible one of the replacements is faulty, so I'll replace. it.

 

[sparkymarka]

You can’t fit two batteries in parallel inside a device ….where did you get that from ?

 

[Robgor]

Are you saying you can’t do this in the outside alarm boxes? Lots of room. If it wasn’t dark I’d go out and take a picture for you.

 

[sparkymarka]

The external has two batteries..if it’s a mk2/3 unit

 

[Robgor]

The external bell box is a Pyronix Deltabell. There is a logo bottom centre.
Originally there was only one battery pack, but as I mentioned it was doubled up.
The battery in my hall sensor was indeed faulty.
Replaced this afternoon and all back to normal now. Cheers