How to display armed status on Pyronix Enforcer panel

W

WillSmyth00

Joined
25 Nov 2018
Messages
14
Reaction score
0
Country
United Arab Emirates
I have my Pyronix Enforcer set up with A (away / all sensors enabled) and B ( home / door & window contacts only) zones. Is it possible to display the armed status of the panel, either on the LCD display or by illuminating the A or B buttons depending on which zone is set.
We set zone B (windows and door sensors) at night and would like to know if the alarm is set by looking at the panel. Currently, I have to use the keyfob check status option.
 
On the display issue - is there a way to have the control unit permanently illuminated rather than going off after one minute ? If so what is the process?
Many Thanks
 
IMG_2300.PNG
 
Thanks Sparky, If I enter 2000 that will perform a factory Reset of all thats been programmed?
 
Ive tried that in any case but when I input the code 2000 then press YES - its sits on a display of the 4 digit code astrix' ...
 
? Have you read the above ... hold down d button on keypad ( from unset ) ...this is NOT done from engineering ....and is NOT a cold start ...
 
You must log in or register to reply here.
Back
Top