How to extend doorbell button cable?

[Techboy]

I'm going to fit a Ring doorbell, so need to extend the doorbell button cable that has previously been cut. There isn't much currently available...

I have tried pulling it to see if it will extend a bit, but it won't.

What's the best solution please?

[GALLERY=media, 106733]20210630_134615 by Techboy posted 30 Jun 2021 at 2:47 PM[/GALLERY]
[GALLERY=media, 106732]20210630_134509 by Techboy posted 30 Jun 2021 at 2:47 PM[/GALLERY]

 

[AndyPRK]

The only thing that will work there is soldering and heat shrink

after careful stripping

 

[JohnD]

surely you can get to the cable on the inside, and joint a new bit on, and poke the new wire through?

was it cut by a vandal?

 

[Techboy]

The only thing that will work there is soldering and heat shrink after careful stripping

Okay, I'll do this. Thanks.

was it cut by a vandal?

No, I think it was done by the previous owner of the house when they fitted the wireless doorbell.

 

[sparkwright]

You could try making a hole somewhere else where you think the cable may run, to gain a SENSIBLE amount of slack cable to joint to.


Good luck with trying to solder onto that little bit of cable...