Kitchen worktop upgrade advice

Joined
6 Jul 2024
Messages
2
Reaction score
0
Country
United Kingdom
Hi

I am grateful for any advice. I am looking to upcycle my dated kitchen worktops - not looking to replace them just now but more something that I, as a complete novice, can attempt.

Has anyone had experience with the worktop wraps or worktop paint. It is laminate worktops currently. My concerns are that wraps might be difficult to apply and end up looking like bubble wrap if I don’t do it correctly. Has anyone used them and found them easy to apply? Re: paint - I suspect even specialist paint might chip or look patchy quickly.

Currently just paid ££ on new bathroom so looking for a temporary fix for now.

Grateful for thoughts. Thank you
 
There's only one worthy make of paint I believe and the choice is black or white I think, possibly grey. If it's only temporary and you accept that then a vinyl wrap will be OK, if you don't fancy DIYing I don't think those wrap specialists charge too much just for a worktop, just treat it kindly and it will last much longer.
 
Hi

I am grateful for any advice. I am looking to upcycle my dated kitchen worktops - not looking to replace them just now but more something that I, as a complete novice, can attempt.

Has anyone had experience with the worktop wraps or worktop paint. It is laminate worktops currently. My concerns are that wraps might be difficult to apply and end up looking like bubble wrap if I don’t do it correctly. Has anyone used them and found them easy to apply? Re: paint - I suspect even specialist paint might chip or look patchy quickly.

Currently just paid ££ on new bathroom so looking for a temporary fix for now.

Grateful for thoughts. Thank you
There’s no cheap easy way to update kitchen worktops .
 
Used this in a bathroom on a single run of 'worktop'
Not too difficult to fit with a bit of care.
Boiler.jpg

Only two adults in our house.
It has picked up a couple of marks in the few years it has been installed.

More likely to get damaged in a kitchen.
If you have a 90 degree joint in the worktop this might be tricky to make neat.
Fitting around sink and hob a bit awkward
 
Thank you everyone. These are helpful and appreciate ultimately I need to replace the worktops. Vinyl may be the way to go for now but will see if I work up the nerve to try it.
 
Hi. I recently refreshed my kitchen. Painted the cupboards and tiles. And used a wrap on the worktop. Didn't find it too difficult to do, just worked very slowly taking the backing off and using a smoother to get the bubbles out a couple of cm at a time. It's visually done the job. But it's not hard wearing. Has some scratches and marks already so you'll need to be really careful woth it. I stripped off all the old sealant and redone it after the wrap was on. I'm pleased with the result and was fairly cheep make over.
 

Attachments

  • 20240322_121655.jpg
    20240322_121655.jpg
    171.1 KB · Views: 33
  • 20240322_121646.jpg
    20240322_121646.jpg
    236.7 KB · Views: 32
Back
Top