My glass hob was installed without a seal. How do I lift it to apply the seal? Here's the installation instruction. The oven is below the hob. I don't think I can access the underside of the hob to get to the clips without removing the oven.
Lifting glass hob
- Thread starter DiyNutJob
- Start date
The oven is secured with 2 screws, possibly 4.
It's literally a 2 minute job to remove it.
The same to put it back.
Yes, that would have worked. But, I can only say that on hindsight.
By some residents of the London zoo. They live somewhere between the big apes enclosure and monkeys enclosure. Bringing them back would risk greater damage. I discovered they stuck on a kitchen trim piece using silicone and oil. It must have taken them quite a bit of effort because it took me quite a bit of effort to reattach without oil and using hybrid polymer sealant.
Last edited:
- Joined
- 7 Sep 2022
- Messages
- 2,764
- Reaction score
- 708
- Country
Suction cup glass lifter? Or one of those suction cup based handles the elderly use to help get in/out of a shower bath? Perhaps even a smaller suction cup off a toy, mobile phone screen replacement kit etc will be sufficient to lift a few mm and let you get some other tool under the edge of the hob
Good idea. Can get a pair of double cups from Amazon for just over a tenner a pair, though one would probably do to lift one side and wedge into place, and then move it to the other side to raise that up.