Hi I have just installed a single light switch dimmer in the living room its a light which is controlling a 3 way light(40w spot R50 x3)
I youtubed a install job and it looked pretty simple so gave it a shot.
Obviously made sure all electrics switched off and test in case of live wires etc.
But I found 2 exact identical red wires inside ?
I connected the top one to L1 and the bottom to L2 on the dimmer, seems to have worked fine but was unsure which one to enter where since both were same I just went for either, hope this was ok !?
but have just noticed a click noise came from it so bit concerned....
I youtubed a install job and it looked pretty simple so gave it a shot.
Obviously made sure all electrics switched off and test in case of live wires etc.
But I found 2 exact identical red wires inside ?
I connected the top one to L1 and the bottom to L2 on the dimmer, seems to have worked fine but was unsure which one to enter where since both were same I just went for either, hope this was ok !?
but have just noticed a click noise came from it so bit concerned....