Were having an extension built on the back of the house. The foundations are exactly where the water meter chamber is. So the meter needs moving. A few years ago we had it all excavated to allow us to replace the lead entering the house with mdpe.
We're on a shared water main. Nobody else is bothered about replacing the lead pipework - frankly I find it ridiculous that the water boards expect 4 neighbours to agree to having their gardens trashed at the same time, and pay to replace the lead. The main lead pipe runs parallel with the back of the existing house, about 2ft away, then tees off to our meter chamber against the house wall. I need to blank off the tee then about 2ft along the main pipe insert a new tee.
Where the existing tee is, will be filled with concrete. Should this be shuttered off from the concrete?
How easy is it for a competent diyer to work with lead and mdpe? Would it be wise to employ a plumber to do this work?
How would I go about blanking off the lead tee? Leave a stub and hammer/melt it flat? Or put a plastic lead stop end on?
What is the best way to create a new tee on the main? Two lead to mdpe fittings and two bits of mdpe with a tee in the middle?
We're on a shared water main. Nobody else is bothered about replacing the lead pipework - frankly I find it ridiculous that the water boards expect 4 neighbours to agree to having their gardens trashed at the same time, and pay to replace the lead. The main lead pipe runs parallel with the back of the existing house, about 2ft away, then tees off to our meter chamber against the house wall. I need to blank off the tee then about 2ft along the main pipe insert a new tee.
Where the existing tee is, will be filled with concrete. Should this be shuttered off from the concrete?
How easy is it for a competent diyer to work with lead and mdpe? Would it be wise to employ a plumber to do this work?
How would I go about blanking off the lead tee? Leave a stub and hammer/melt it flat? Or put a plastic lead stop end on?
What is the best way to create a new tee on the main? Two lead to mdpe fittings and two bits of mdpe with a tee in the middle?