Only been in this house few months, so haven't got 'acquainted' with our boiler yet. Back from holiday two months ago and spanner was showing and 0.4 pressure. Put on heating to test it and it fired up OK. Relief all round.
Two days ago, we go dreaded F22 error and nothing was working, heating nor hot water.
In previous house, had simple two-valve system to re-fill but here, I have no idea how to do it.
Here's an image of the underside - I've seen many other photos of 618 boilers showing nice plastic valves underneath. We don't have any of that. Here's our boiler from below:
I'm guessing I need to attach something to the first and third pipes?
The boiler is set up in our lean-to shed out the back and I see nothing else obvious where re-pressuring could happen. There's also tank up in the loft space above the bathroom, is it likely to be there?
Happy to post other photos - would rather avoid a plumber call out if there's something right under my nose.
Two days ago, we go dreaded F22 error and nothing was working, heating nor hot water.
In previous house, had simple two-valve system to re-fill but here, I have no idea how to do it.
Here's an image of the underside - I've seen many other photos of 618 boilers showing nice plastic valves underneath. We don't have any of that. Here's our boiler from below:
I'm guessing I need to attach something to the first and third pipes?
The boiler is set up in our lean-to shed out the back and I see nothing else obvious where re-pressuring could happen. There's also tank up in the loft space above the bathroom, is it likely to be there?
Happy to post other photos - would rather avoid a plumber call out if there's something right under my nose.
