Old elbow need stop end cap..

[GoodOne]

Hiya,

I need to put a stop cap/end on one of this old elbows.

What I would like to know is by looking at the picture, does anyone one knows if I could get a stop cap with this kind of old elbow?

Btw the pipe size is 15mm.

Cheers!

 

[45yearsagasman]

There probably are caps to seal on of the branches of you Tee, but consider cutting the copper, leaving enough to fit one of these compression stop ends:-[GALLERY=media, 41692]Untitled by 45yearsagasman posted 17 Jan 2012 at 1:11 PM[/GALLERY]

 

[oldbuffer]

Conex 323 stop end - 15mm. http://www.conexbanninger.com/search.php?brands_id=7&shortcode=323

But probably any 15mm compression stop end would fit.

 

[Terrywookfit]

Prestex 37A blanking disc.

 

[FiremanT]

That is a tee, not a elbow. Remove the tee, fit an elbow, leaving the leg you want capping islolated.
Unless I have the wrong end of your stick?

 

[Terrywookfit]

That is a tee, not a elbow. Remove the tee, fit an elbow, leaving the leg you want capping islolated.
Unless I have the wrong end of your stick?

Fookinell....That was observant of you !!

 

[GoodOne]

Oops.. sorry. Ya it's a tee.

Btw I need to remove the hot water, it connects to the washing machine.

 

[FiremanT]

The easiest solution is to remove the valve, and use the cap section of the cap suggested by 45 years above. Pendants will call this a dead leg, which is true, but I, personally, would not worry about it.

I will await flak.

Terry, I 'm not sure if you are being sarcy?

 

[GoodOne]

Would you think one of this would fit in the tee?

https://www.toolstation.com/shop/Plumbing/d20/Compression/sd2697/Brass+Cap/p39682

 

[Madrab]

Get a 3/4" one of these

or a 3/4" one of these with a rubber washer inside

and bang it on the end of the valve, after turning it off and taking the pipe off of course.