Not sure if this topic is even covered here?
I have an oleo mac 27cc Strimmer.
From engine idle to acceleration/cutting the engine cuts out. Also hard to start.
When I adjust the high & low carburettor adjustment screws everything works fine for a few weeks then it does the same thing again.
When I adjust the high & low screws again it works fine but does the same thing a few weeks later.
What's going on?
(The screws are tight)
The Strimmer is fairly new & hasn't had much use.
Worst Strimmer I've ever bought.
I had a 30 year old marunaka Strimmer which I gave to my brother & it's still working as good as the day I bought it.
Apart from a needing a new coil pack!
I have an oleo mac 27cc Strimmer.
From engine idle to acceleration/cutting the engine cuts out. Also hard to start.
When I adjust the high & low carburettor adjustment screws everything works fine for a few weeks then it does the same thing again.
When I adjust the high & low screws again it works fine but does the same thing a few weeks later.
What's going on?
(The screws are tight)
The Strimmer is fairly new & hasn't had much use.
Worst Strimmer I've ever bought.
I had a 30 year old marunaka Strimmer which I gave to my brother & it's still working as good as the day I bought it.
Apart from a needing a new coil pack!