Pyronix enforcer - how to temporarily disable alarm to fit new batteries in sensors?

[km011b3870]

Hi everyone

I need to change the batteries in the sensors. Last time I did this, opening each one set off the alarm with a tamper alert. I think there is a way to disable it or put it in some mode so it won't do this then I can just change it back.

Can anyone help me, please?

Thanks

 

[sparkymarka]

Unless you have the engineer code …..then no ….what’s the big deal with entering the code to stop the tamper alarm while you swop out the battery ? It’s only sounding internally!

 

[km011b3870]

I do have the engineer code.

I think from memory it set of the siren too? Not totally sure it's a while ago but I've got a few to change.

 

[sparkymarka]

Go into engineer programming , then change your batteries then exit engineer programming !

 

[km011b3870]

Hey so I pushed D then entered the code and thought this was the engineer menu but it still set off. Am I doing it wrong ?

Thanks

 

[sparkymarka]

So ….no you don’t have the engineer code ….entering the engineer code would say ….inhibit fire ….you would press yes …or no

 

[km011b3870]

Ah ok . Thanks. It's just in the menu that comes up it allows me to enable and disable the engineer menu which I thought would be odd for a standard user to be able to do so thought it must be the engineer code.

Thanks !