Hi Folks, I have recently install a new wireless system complete with the wireless Deltabell. Everything is working fine apart from the final beep to show the system is alarmed. The control box beeps but the deltabell doesn't. I have checked over and over but can find nothing in the instructions or on the internet regarding this. Have I missed a jumper or switch? Also is there any way of doing a full arm on the panel without having to open the final exit door? I do tend to arm off my phone most of the time but it is sometimes a little bit of a nuisance. Any help would be appreciated.
Pyronix Enforcer v11 Deltabell
- Thread starter Dal;esman
- Start date
- Joined
- 17 Jul 2018
- Messages
- 402
- Reaction score
- 31
- Country
Is there any reason you want the bell to confirm the system is armed? I ask only because it will drain your deltabell batteries quicker. If despite this you want the feature turned on you’ll find it within system options and under strobe/squawk at set
Regarding the final exit door change the exit mode to timed/final rather than final
Regarding the final exit door change the exit mode to timed/final rather than final
At the risk of sounding obvious, I want the bell to confirm that the alarm is actually armed before I walk away.
I can't see that the short squawk will drain the batteries much quicker especially as the V10 system we installed in other premises 2.5 years ago are still going strong with the squawk on.
I had a quick look last night to try and find the settings but was unable to - I will take more time today to go through the menus. Thanks for you prompt help.
I can't see that the short squawk will drain the batteries much quicker especially as the V10 system we installed in other premises 2.5 years ago are still going strong with the squawk on.
I had a quick look last night to try and find the settings but was unable to - I will take more time today to go through the menus. Thanks for you prompt help.
- Joined
- 17 Jul 2018
- Messages
- 402
- Reaction score
- 31
- Country
The bell strobing or squawking every time the alarm is set will absolutely drain the batteries quicker than if it wasn’t.
I’m not surprised that 2.5 years in on the other system you haven’t had any problems, I’m managing systems without strobe/squawk where the bell batteries are still going strong 5 years in.
I’m not surprised that 2.5 years in on the other system you haven’t had any problems, I’m managing systems without strobe/squawk where the bell batteries are still going strong 5 years in.
Another option ,you could put arming/disarm notifications from the app.
This will tell you when the alarm is set and unset.
You need to turn this function on from your cloud account settings.
