Hi all - I'm struggling with the alarm system in our new house. The old owners obviously had ARC monitoring previously, which expired. The alarm was setting and unsetting fine for a while. Now when I unset it at the front door the LCD says 'ARC call fail' and emits two bleeps followed by two higher bleeps until you enter code and NO a few times. I believe the front door one also bleeps when we set the downstairs one from our room at night.
I think I've turned off ARC calling from the normal menu, but I imagine I need to do this in the Engineer Menu? Or worst comes to worst turn off technical fault sounds from the Engineer Menu? However, typing in 1111 just sits there as **** and then eventually reverts to showing the time again (D-> gets into the normal menu). I have also checked to see if Engineer Menu is set to YES, and it is. As well as stopping it trying to contact the ARC, I imagine I need to clear the fault too? The Pyronix manual is as clear as mud. Any ideas?
I think I've turned off ARC calling from the normal menu, but I imagine I need to do this in the Engineer Menu? Or worst comes to worst turn off technical fault sounds from the Engineer Menu? However, typing in 1111 just sits there as **** and then eventually reverts to showing the time again (D-> gets into the normal menu). I have also checked to see if Engineer Menu is set to YES, and it is. As well as stopping it trying to contact the ARC, I imagine I need to clear the fault too? The Pyronix manual is as clear as mud. Any ideas?
Last edited:
