Pyronix Euro46 Zone setting

S

sparklymarkly

Joined
16 Nov 2005
Messages
44
Reaction score
0
Location
Nottinghamshire
Country
United Kingdom
Hi all
I have replaced my old alarm system with a Pyronix Euro46 - all hardwired as cabling was already in place.
Endless visits to this site (thanks all!) and Youtube have got me so far - It's all functioning now but try as I might, I can't seem to just part set the system.
I have 5 PIRs - one is the entry/exit zone (hall) and all except one are downstairs.
I have configured all the downstairs ones to areas A & B and the one on the landing to just Area A. The keypad/reader is in the hall and set up is being in A/B.
However, if I try to set the system as just B (bedtime), if I walk past the landing PIR it still sets off the alarm.
Both users have been allowed access to all areas and Flexi setting during set up.
I know this must be something really simple that I've not done in the programming but I'm stuck now and if I had much hair I'd be pulling it out!
Any advice would be welcome. Thanks in advance.
 
And are u sure the landing sensor is labelled correctly. If u take the lid off in day mode does it show landing
 
Definitely labelled correctly (I just whipped the cover off the main box and double checked the wiring!)
I must admit I haven't checked Level Set - I'll take a look now (don't know what it means though!).
 
Level Set wasn't enabled when I checked.
I enabled it but then if I put code in, it just went straight to Quick set of area A with no option to change anything.
So I un-abled it again.
 
Level set - If ‘Yes’, the system becomes ‘level set’ (having one area set only at any one time). If ‘No’: The system becomes an ‘area’ system (fully independent areas).
 
Level set should be on. Under assign keypads 00 should sets AB unsets AB and IN AB
 
Bigsosij said:
Level set should be on. Under assign keypads 00 should sets AB unsets AB and IN AB
Click to expand...
OK so keypad is as above - sets AB, unsets AB and in AB
Intelligent Set is disabled
To start, I didn't enable level set again (see above when I did) but when I entered code, I get A & B zone lights coming on and FULL SET message on display but no way to change that setting.
I then enabled Level set again but I only get Zone A light and full set option showing!
 
So when level set is enabled does it say set areas? A
At which point you should be able to change it to B and press yes
 
Right - made some progress!
Flexi set wasn't set up properly. I didn't realise that when you set up a tag with the same name as a user, it was actually two separate users (if that makes sense? I thought it combined them). :cry:
I'd enabled both tags as flexi set but not the users with the same name (me & Mrs).
Done that now and I can part set with both users so that's great & I am very grateful :) but still one issue.
When part set, I can dance around in front of the landing PIR without triggering which is great but the hall PIR (in front of the keypad) didn't recognise me when I came downstairs. Alarm only triggered when I walked into the lounge (another PIR).
I assume I have set up the hall PIR wrongly?
It's set as 07 Final Exit at the moment but not sure that's correct?
What should that be set as if it's the entry point (there's no door sensor on front door so this is the first & last point)?
 
You must log in or register to reply here.
Back
Top