- Joined
- 20 Sep 2022
- Messages
- 2
- Reaction score
- 1
- Country
Hello,
I'm looking to replace two Danfoss TP5000-m's with two TPOne-M's, and want to check the wiring.
My system has a combi boiler with two heating zones (living room and rest of house) each controlled with a separate TP-5000M. The hot water is not controlled by the TP5000's. There is also what appears to be two motorised valves. I was only looking to do a straight swap for the TP-5000's with more modern units, and hoping to do the switch myself.
Looking at the wiring guide for the TPOne-M...
It's clear to me where the incoming L and N will go, can you confirm where the other wires should go?
And secondly, would the TPOne-M's just work out of the box or would any settings need to be changed?
Many thanks,
Richard
I'm looking to replace two Danfoss TP5000-m's with two TPOne-M's, and want to check the wiring.
My system has a combi boiler with two heating zones (living room and rest of house) each controlled with a separate TP-5000M. The hot water is not controlled by the TP5000's. There is also what appears to be two motorised valves. I was only looking to do a straight swap for the TP-5000's with more modern units, and hoping to do the switch myself.
Looking at the wiring guide for the TPOne-M...
It's clear to me where the incoming L and N will go, can you confirm where the other wires should go?
And secondly, would the TPOne-M's just work out of the box or would any settings need to be changed?
Many thanks,
Richard