Scantronic 9651 low battery

F

Fergalcat

Joined
24 May 2018
Messages
6
Reaction score
0
Country
United Kingdom
Hi all,

Bleeping from keypad showing low batt. I just purchased a new back up battery 12v 7ah & have a user guide, however it would appear the installer code had been changed from the factory default.

Any ideas how I can replace the battery without the installer code or will I need to find the original installers to replace it?

Thanks in advance
 
No just open it up , enter your code , replace battery , reset ......But if it's engineer reset on panel tamper your going to have to come back on for further info
 
Thank you for quick reply, much appreciated. Will give it a try and get back to you.

Thanks again.
 
Thank you so much Sparkymarka
15271924485441794478936.jpg
15271924485441794478936.jpg

Set and unset ok all good apart from the time.

Battery had 2006 date on it!!
 
Sparkymarka I've got a 9651 what is beeping and saying battery low and engineer reset could you help please
 
First job , Replace battery ...take old one out ....go to screwfix etc ....get replacement .
Do you have engineer code ?
 
Hi Sparkymarka, I've got a 9651 that is beeping every 15min showing battery low and engineer reset, can you please advise what to do if I have no engineer code.
 
Understand battery replacement. I have no engineer code, is there a workaround?
 
its asking for an engineer reset code which I do not have. What should I do?
 
You must log in or register to reply here.
Back
Top