Hey all,
I've got a SMEG DIC410 which started leaking condensation on the left side of the door. This started causing warping of the kitchen cupboard door/panels.
I've moved the dishwasher out to avoid any further damage. I've also replaced the the door seal and this hasn't resolved my problem.
The only thing that was common but strange between the old seal and the new seal was that the part where the condensation was leaking during operation did not properly stay fitted into the recess. The entire seal is secure besides this small part (see photo below). The seal has no adhesive so I'm not sure why its not fitting tightly here (no dirt/food and it doesn't look like its wider than the rest). Has anybody else seen this / would some fo
rm of adhesive glue be recommended?
I've got a SMEG DIC410 which started leaking condensation on the left side of the door. This started causing warping of the kitchen cupboard door/panels.
I've moved the dishwasher out to avoid any further damage. I've also replaced the the door seal and this hasn't resolved my problem.
The only thing that was common but strange between the old seal and the new seal was that the part where the condensation was leaking during operation did not properly stay fitted into the recess. The entire seal is secure besides this small part (see photo below). The seal has no adhesive so I'm not sure why its not fitting tightly here (no dirt/food and it doesn't look like its wider than the rest). Has anybody else seen this / would some fo
rm of adhesive glue be recommended?