Texecom alarm won’t sound when armed

C

Connor999

Joined
22 Jul 2024
Messages
8
Reaction score
0
Country
United Kingdom
I’ve recently installed a premier elite 24 system and upon entry to the property there is no entry tone and the alarm won’t sound.

I get an exit tone, and when entering it says Area A arm etc but there is no sound on entry.

I have no door contacts and have the PIR on the entry hallway as entry/exit.

I have programmed via the keypad.

All PIRs pass a walk test, with a bell test also successful.

Could anyone give any advice on this issue
 
All active zones just have Area as A. in zone setup via the keypad.

Any other advice?
 
A correction to my original post - when I do the walk test via Engineer Utils it comes up with an error message of *NONE* but they have an LED on the PIR when walking past.
 
Capture P15 PIRs. When I activate the PIR, and review zone status it goes from 000R to 04K680 so believe it is resistors?
 
I’ll have to look at the jumpers on one of the PIR tomorrow but don’t think I changed any from the box.

Is there any other cause of why I wouldn’t be getting any resistance when closed?
 
Should be like this
Screenshot_20240723_230637_Drive.jpg
 
You must log in or register to reply here.
Back
Top