Texecom EOL wiring 2 devices - 1 zone

I

iimatas

Joined
23 Jan 2022
Messages
3
Reaction score
0
Country
United Kingdom
Hello,
Could someone please help me out in understanding how to wire two EOL devices to the same zone? I've been trying to look online, but I'm struggling to understand. Would someone perhaps be able to show me how I'd wire it, assuming you put the same of the two diagrams side by side?

I've got two Impaq SC's, this is how they look:

1682179105875.png


Appreciate your help
 
Instructions state to wire contact on own zone and shock on own zone,otherwise device will not operate correctly.
Google shock sensor and Facebook has video on how to wire and setup correctly.
 
@Handymanjo Sorry, but that's not what I meant - I can wire shock and magnet onto a single unit. But I want to wire two of these units to the same zone
 
That's not advisable with that device, as it recommends not to in the instructions.
 
@Handymanjo I understand that it’s not advisable to wire two devices to the same zone, due to fault finding. I’m just simply asking if someone can help me on how it can be done, not whether it’s advisable
 
Do you have a pack of resistors ?

In theory it should be possible to get EOL to work across the shock and mag on one zone.

What values are you using?

There are numerous diagrams on here about wiring eol devices.

Should always follow the manufacturers recommendations though.
 
You must log in or register to reply here.
Back
Top