Texecom Premier 48 Help! arming goes on forever...

[windswept321]

I have a texecom premier 48 (older panel) I installed a while back but cannot get it to finish arming and never have managed it... It just keeps buzzing and claiming it will arm but never does, until cancelled with the user password.

I can't see anything obvious in my settings that would cause this. Also, if instantly armed in Wintex it works ok. Any ideas?
Here are screenshots of my settings.

 

[sparkymarka]

It's set to entry/ exit which you have to open the entry exit door for it to set , set it to timed ...
First screen shot

 

[secureiam]

ditto

 

[sparkymarka]

Quite a few other things need turning off / confirmed eng reset , no ATS eng reset ect

 

[secureiam]

beneficial for your own system, but need maybe a little strong.

 

[windswept321]

Thanks for the advice. I will try it out tomorrow - sounds like I really misunderstood the entry/exit settings!