- Joined
- 29 Dec 2016
- Messages
- 1
- Reaction score
- 0
- Country
Hi
I'm trying to integrate my current Texecom Premier 832 alarm system with Xcomfort. I can use the outputs and connect these to an Xcomfort binary module.
I would like to have a pulse triggered when the events below occur. I believe I have figured out no. 1-3, but the motion trigger (also when alarm is not activated) I'm not sure about. Any ideas? Can this be done using the Zone mimic (group 3 outputs)?
1. Burglar alarm activated (OK: "0-2 Burglar Alarm")
2. Fire alarm activated (OK: "1-0 Fire")
3. Burglar system armed (OK: "1-6 Armed")
4. Motion in various zones ?
If anyone has ideas for how to best do this it would be greatly appreciated!
I'm trying to integrate my current Texecom Premier 832 alarm system with Xcomfort. I can use the outputs and connect these to an Xcomfort binary module.
I would like to have a pulse triggered when the events below occur. I believe I have figured out no. 1-3, but the motion trigger (also when alarm is not activated) I'm not sure about. Any ideas? Can this be done using the Zone mimic (group 3 outputs)?
1. Burglar alarm activated (OK: "0-2 Burglar Alarm")
2. Fire alarm activated (OK: "1-0 Fire")
3. Burglar system armed (OK: "1-6 Armed")
4. Motion in various zones ?
If anyone has ideas for how to best do this it would be greatly appreciated!