Hi, I have had the Texecom Premier Elite 64 for a couple of years now but Im not really happy with it - lots of little things. I'm considering just removing the entire system. I'm a DIY newbie, and would appreciate some guidance on easiest way to do this?
In terms of setup - I have the main panel, a couple of PIR motion sensors, a door sensor and an outside alarm, and the control number panel.
I want to do this without accidentally triggering and tamper or setting off the alarm.
I know both my user and engineer code.
As an aside -
1. Im getting a "battery fault" message on the control panel - I think this means the battery in main panel needs to be replaced (havnt replaced it - dont know how for 3 years).
2. I previously could log in through wintex on my pc - but for some reason this has stopped wording - it wont connect even though I none of the settings have changed. Can I remove the whole system without "access".
Thanks in advance
In terms of setup - I have the main panel, a couple of PIR motion sensors, a door sensor and an outside alarm, and the control number panel.
I want to do this without accidentally triggering and tamper or setting off the alarm.
I know both my user and engineer code.
As an aside -
1. Im getting a "battery fault" message on the control panel - I think this means the battery in main panel needs to be replaced (havnt replaced it - dont know how for 3 years).
2. I previously could log in through wintex on my pc - but for some reason this has stopped wording - it wont connect even though I none of the settings have changed. Can I remove the whole system without "access".
Thanks in advance
Last edited:
